Ultra-sPILL DECK INLINE Model

No. Spilled liquids will more than likely cause the internal surfaces of the bladder to adhere to each other. We cannot guarantee the proper deployment of a reused bladder..

We recommend using a pump (Product CHU2345 can be used) to remove any spilled contents from the sump. (Note: spillage should be pumped into an approved container).

The spill deck ramp (Product CHU1089) comes complete with two steel clips that quickly install on the end of the ramp. These clips hook onto the connecting spill deck and keep the ramp from moving or shifting during loading or unloading. NOTE: The ramp is not designed to be used with the 1-Drum spill decks or the short side of the 2-Drum spill decks.

Other than the spill deck, you’ll need one bulkhead fitting (Product CHU1073) and one t-strip ( Product CHU1131) for every 660mm of spill deck length that is connected. For example, if you’re connecting a 4-drum spill deck to another 4-drum spill deck you would need two bulkhead fittings and two t-strips. If, on the other hand, you were connecting a 1-drum spill deck to the short end of a 2-drum spill deck, you would only need one each of the bulkhead fitting and t-strip.

Yes, all grating surfaces on the spill decks are slip-resistant.


The spill deck can NOT be moved with a forklift or pallet jack. The design of the spill deck sidewalls sometimes leads users to think that it is forkliftable or able to be moved with a pallet jack. But what may appear to be forklift pockets are actually supports for the grating.

The t-strips lay across the point where two spill decks come together. By “bridging the gap” this piece diverts spills to either of the decks and keeps any spillage from getting between the units.

(Note: The answer to this question is based on one assumption: That the spill decks are being used with 205 litre drums). Yes, all the Ultra Spill Deck Inline InLine Models meet EPA requirements.

All other spill decks use a grating that is 1219mmL x 609mmW x 63mmH or 609mmL x 609mmW x 63mmH.

The replacement bladder ( Product CHU6340) is what you would need to order. It is just the bladder and does not include the outer housing. The bladder attachment (Product CHU2317) includes a bladder and the outside housing.

The bladder will roll out 1663mm away from the deck and will be 1676mm wide when completely unfurled.

The bladder(s) should be replaced for any of the following reasons: (1) It captures a spill (regardless of the size of the spill), (2) It deploys, rolls, or falls out of the bladder attachment housing. (3) It has been sat unused for more than five years.